Vallas Aluminio MálagaAluminium & steel slat fencing
Panel (slats / mesh)Strip footingLow wall (murete)PillarPanel (slats / mesh)Ground
Wall guide

Fixing a slat fence to an existing wall: what we check first

Reusing a sound wall is sensible. Bolting a tall screen onto a wall that was never designed for it is one of the most common causes of cracked, leaning fences we are asked to fix.

Technical guidesLast reviewed: Bauman Raymond Attila

Why does an existing wall need checking?

In short: because adding slats turns a self-standing wall into the base of a fence that catches wind, and many walls were not built for that.

A low garden wall on its own carries its own weight and little else. Add a slat screen on top and the situation changes: the wind acting on the screen pushes on the posts, and the posts pass that force into the top of the wall as a lever. The taller and more closed the screen, the greater the effect.

A wall built with that in mind – solid or reinforced where the posts go, with a footing to match – handles it well. A wall built only to define a boundary may not. The result shows up as cracks around fixings, loose base plates or a wall that slowly leans. Our wind and slatted fences guide explains the forces involved.

What do we look at on site?

In short: construction, condition, thickness, plumb, the top of the wall where fixings go, and what is on the other side.

When you ask us to reuse a wall, we check:

  • What it is built from – solid or hollow block, brick, stone, concrete – and whether it appears to be filled or reinforced where we would fix posts.
  • Its condition – cracks, especially stepped cracks, loose render, damp, crumbling at the top.
  • Plumb and line – a wall that already leans will not improve under a fence.
  • Thickness and the top surface – base plates need sound material to anchor into.
  • The footing, as far as it can be seen or deduced.
  • The other side – whether the wall holds back soil or belongs partly to a neighbour.

We may make a small exploratory opening at a future fixing point to see what is inside. Photos of both sides of the wall, from close and from a distance, help us give a first view remotely.

What if the wall holds back soil?

In short: then it is a retaining wall, not a fence base; it needs a technician's assessment, and we do not build or alter retaining walls.

If the ground is higher on one side of the wall than the other, the wall is retaining soil. That is a structural element with its own design requirements. A fence is not a retaining wall, and putting a screen on top of one adds loads it may not have been designed for.

In that case we recommend an assessment by a technician – arquitecto, aparejador or ingeniero – before anything is fixed to it. We do not offer retaining walls or structural calculations. The specialists at murosdebloquemalaga.eu explain the difference between a garden wall and a retaining wall in detail. Spain's building code (CTE) includes basic documents on foundations and masonry that technicians use for such assessments.

What fixing options are there?

In short: base plates on the wall, posts set into a rebuilt wall top, slats between pillars, or a new wall where the old one is not suitable.

Depending on what we find, the options are:

  • Base plates anchored into the wall top, where the wall is solid and in good condition.
  • Rebuilding the top courses with filled or reinforced sections at the post positions, then fixing the posts.
  • Building pillars at intervals and running the slats between them, which takes load away from the old wall.
  • Posts with their own footings behind the wall, so the wall carries nothing.
  • Replacing the wall with a new murete designed for the fence, when the old one is beyond reasonable repair.

The page on the aluminium fence on a wall shows how we build when the wall is new.

How are stepped walls on slopes handled?

In short: horizontal slats follow the steps of the wall in level sections; vertical slats can follow a sloping wall top.

On hillside plots, walls are often stepped. Horizontal slats sit naturally on a stepped wall, each section level with its step. Where the wall top slopes instead of stepping, vertical slats on rails parallel to the wall usually give a cleaner line.

Either way, the fixing points need sound material. The ends of each step are often the weakest part of an old wall, and they are exactly where posts tend to land, so we check them carefully.

Can you fix to a wall shared with a neighbour?

In short: only with the neighbour's agreement, ideally in writing; otherwise build on your own side.

Walls on the lindero are often shared. Fixing a fence to a shared wall, raising its height or changing its appearance without agreement is a common source of disputes. Agree it in writing first, or plan the fence on your side of the line with its own posts and footings.

Our main site's guide on boundary and party walls covers the wider questions.

Official sources

BR
Bauman Raymond Attila
Author and person responsible · Last reviewed:
FAQ

Frequently asked questions

Can any garden wall take an aluminium fence?

No. It depends on the wall's construction, condition and the height and type of screen. We check before recommending a fixing.

What are the warning signs of an unsuitable wall?

Stepped cracks, crumbling top courses, leaning, damp patches and hollow blocks with no fill where posts would go.

Do you need to open up the wall?

Sometimes we make a small opening at a future fixing point to see what is inside. We agree this with you first.

Can a cracked wall be repaired and reused?

Sometimes, if the cracks are minor and the cause is understood. Structural cracks need a technician's opinion.

Is it cheaper to reuse the wall?

Often, but not always. Reinforcing or partly rebuilding a wall can approach the cost of a new one; we price the options.

My wall retains soil – can you put slats on it?

Not without a technician's assessment first. A fence is not a retaining wall, and we do not build or alter retaining walls.

Can you build pillars against the old wall?

Yes, new pillars on their own footings can carry the slats and take load off the old wall.

What about walls with a coping on top?

The coping may need to be lifted or drilled for fixings and then sealed. We plan this so water does not get into the wall.

Can photos be enough for a first opinion?

Photos of both sides, close-ups of cracks and the top of the wall help us give a first view. A visit is needed before the final quote.

Can you remove the old wall?

Removing an old fence is part of our work when building the new one. Larger wall demolition is handled by our demolition partners.

Get a quote

Planning a slat fence for your villa?

Send photos of the boundary and the approximate length. We reply with a first assessment and, after a visit, an itemised quote with no commitment.